If you are working with the driver downloaded from the Cisco Downloads, go to the directory to which you saved the file. Unpack the archive by using the tar command. If you downloaded an updated version of pcmcia-cs, unpack it also. Previous versions of the Linux drivers allowed you to specify the directory to which the client utilities would be installed, but in version 1.
The help files are also installed to this directory. When the script has finished installing the files, press Enter to continue. The install script prompts you for the name of the web browser to use to display help files.
You are asked if you use a Red Hat Linux system with an unmodified kernel. If so, see the Install on Red Hat 7. If not, proceed to the next step. The installation script verifies that you have already unpacked version 3. If you have not already unpacked the files, the script gives instructions for downloading and unpacking the card and socket services.
Once this is accomplished, rerun the installation script. Note: If you want to use a different version of card and socket services, you can break away from this installation to obtain a different version from the Internet from sites like SourceForge and then continue the installation. The driver files are copied and you are presented with a list of commands to perform in order to install the card and socket services. Complete the appropriate procedure that remain in this document in order to finish the installation based on the type of drivers you are installing.
If you install PCMCIA drivers, change to the directory into which the driver files were unpacked, then type make config. When you are prompted to respond to a series of questions, press Enter to accept the default value for each question, or select a different alternative as appropriate.
When the make all command is finished executing, type make install and press Enter. See the man page for the shell you are using for the correct syntax. Proceed to Set Utility Permissions. Red Hat and other distributions that use linuxconf should use that utility to tell the operating system that the airo. Users of other distributions should follow their distribution's recommendations on which startup files should load the driver. Slackware distributions prior to 7.
Red Hat 7. No compilation is needed. This is recommended for systems installed with the "workstation" configuration. This requires a complete kernel rebuild and installation. This is probably the most advanced installation method. N95, KN95, KF94 masks. Microsoft is done with Xbox One. Windows Windows. Most Popular. New Releases.
Desktop Enhancements. Networking Software. Trending from CNET. Visit Site. Clicking on the Download Now Visit Site button above will open a connection to a third-party site. Developer's Description By Cisco Systems. Full Specifications. What's new in version 7. Release August 26, Date Added July 1, Enter the path to the location where you extracted the Windows 95 driver files in the Select Other Location window.
Note: Windows does not use case-sensitive paths and filenames. If a window appears that indicates that the pcx If you are prompted to insert the Windows 95 operating system disk, click OK and do one of these steps:. When you locate the files, type the full path in the Copy files from field, then click OK to copy the required files. Click OK to copy the required files.
Select Client Name from the Property column on the left of the window. Type the unique client name of your computer in the Value field. The client name montecito is shown here for demonstration purposes only. You may need to contact your network administrator to determine the correct client name.
The default SSID tsunami is shown here for demonstration purposes only. You may need to contact your network administrator to determine the correct SSID to use. Click OK to close the Properties window. Click Properties and select the IP Address tab. Select the Gateway tab and type the default gateway address for your computer.
This information can be obtained from your system administrator. If you use ACU version 5. In the Authentication Method window, select the server-based authentication method preferred for wireless network access in your location and click Next. If you select None the default value , server-based authentication is not enabled for your client adapter. After the client utilities are installed, you can elect not to implement any security features, or you can activate some level of security by using WEP keys.
EAP is not available in all versions or for all operating systems.
0コメント